To prevent carpet damage, do not lean on the vacuum or let the powerfoot tilt forward. Do not place vacuum cleaner close enough to objects to pull them into rotating brush. Never place the powerfoot on furniture or uneven surfaces. Never place your fingers under the cleaner when it is running. Always place the cleaner on the floor with the handle in the upright position when using tools. To reduce the risk of injury from moving parts, always move the cleaner with the carry handle at the front of the unit. The rotating floor brush continues to rotate while tools are in use. DO NOT operate your vacuum without these filters. WARNING Before using your vacuum, make sure that the dirt container is in locked position and that all filters, both pre and post-motor filters are in place. Repeated strokes in the same area may enhance this condition. NOTE: Some frieze and berber carpets have long delicate fibers or threads that may be damaged by rotating brush. If your vacuum becomes too difficult to push, just move to a higher setting. Simply turn the knob towards the desired flooring type. You can easily raise or lower your vacuum to adjust to different flooring types. When you’re finished, lean it all the way back up to lock it into the upright position. To get even lower, press the recline pedal a second time. Press the recline pedal to lean your vacuum back for cleaning. Press it again to turn your vacuum off when you’ve finished cleaning. Press the red power switch with your foot to turn on your vacuum. You can remove it to use it and put it back to store it neatly out of your way when you’re finished. NOTE: The crevice tool can be found inside the extension wand. Put your accessory tools on the vacuum and you’re ready to go! Now wrap the hose through the hose clip and connect the hose wand to the foot hose down at the bottom of the vacuum.
Next, insert the end of the hose into the back of the vacuum and twist to lock it into place. Then wrap the power cord around the cord release clips and clip the end of the plug to the power cord. Next, insert the lower cord wrap and turn it to the left to lock it into place. Then attach the handle with the 2 screws that are taped to the handle in a plastic bag.
Do not use with any opening blocked keep openings free of dust, lint, hair, and anything that may reduce air flow. Do not handle plug or vacuum cleaner with wet hands.
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY: When using an electrical appliance, basic precautions should be observed, including the following: Unplug from outlet when not in use and before conducting maintenance. READ ALL INSTRUCTIONS BEFORE USING YOUR UPRIGHT VACUUM.Īlways connect to a polarized outlet (one slot is wider than the other).
17 Related Manuals / Resources IMPORTANT SAFETY INSTRUCTIONS